![]() |
| |||||||||||||||||||||||||||||||||||||||
|
|
#3 | ||||||
|
Bring one of your ejector guns to the Southern and I'll demonstrate for you.
|
||||||
|
|
|
||||||
|
|
#4 | ||||||
|
I'm not going to the Southern.
I can fire both hammers, remove the fore end, remove the barrels, replace the barrels, snap the fore end right back on, open the gun and the ejectors trip as they normally would. I can do this on each and every ejector gun I own. It there is something wrong with the gun, and the ejector hammers are firing when the gun is fired, before opening the gun, or if they are tripping when you remove the fore end, you need to make a trip to the smithy. If I'm misunderstanding what you're saying, tell me what I don't get. As I recall, when you brought this up before, all the other posters replied that they had no issues removing and replacing the fore end on a gun when the hammers were down. |
||||||
|
|
|
||||||
|
|
#5 | ||||||
|
If I take ANY ejector gun I have open it, put snap caps in and dry fire it. Now take the forarm off and I'll have to manually recock the ejector cams in the forarm befor it will go back on.
|
||||||
|
|
|
||||||
|
|
#6 | ||||||
|
|
||||||
|
|
|
||||||
|
|
#7 | ||||||
|
Perhaps I'm not explaining it very well. robin you were at Haussmanns when the forarm popped off the trap gun and you and Suponski helped to recock the ejectors. Give me one of your ejector guns at a shoot and I'll show you what I'm talking about.
|
||||||
|
|
|
||||||
![]() |
| Thread Tools | |
| Display Modes | |
|
|