Dry firing a hammer Parker

[Big D]

Mills - One low budget approach is to put pencil erasers in the primer pockets and snap away

[C.O.B.]

On my hammerguns I gently release the hammer by using my left hand to control it. No slamming on an empty chamber. I leave all my hammerless guns cocked. Take the forarm off an ejector gun thats not cocked to put it in a gun case and you won't make that mistake again

[edgarspencer]

Originally Posted by Rich Anderson

Take the forarm off an ejector gun thats not cocked to put it in a gun case and you won't make that mistake again

You've said this before, and it made no more sense this time than when you said it the first time. The ejectors will remain cocked when you take you fore end off, unless there's a mechanical issue that's making them trip. I have no issues with ANY of my ejector guns, Parker or otherwise.

[C.O.B.]

Bring one of your ejector guns to the Southern and I'll demonstrate for you.

[edgarspencer]

I'm not going to the Southern.
I can fire both hammers, remove the fore end, remove the barrels, replace the barrels, snap the fore end right back on, open the gun and the ejectors trip as they normally would. I can do this on each and every ejector gun I own.
It there is something wrong with the gun, and the ejector hammers are firing when the gun is fired, before opening the gun, or if they are tripping when you remove the fore end, you need to make a trip to the smithy.
If I'm misunderstanding what you're saying, tell me what I don't get. As I recall, when you brought this up before, all the other posters replied that they had no issues removing and replacing the fore end on a gun when the hammers were down.

[C.O.B.]

If I take ANY ejector gun I have open it, put snap caps in and dry fire it. Now take the forarm off and I'll have to manually recock the ejector cams in the forarm befor it will go back on.

[edgarspencer]

Originally Posted by Rich Anderson

If I take ANY ejector gun I have open it, put snap caps in and dry fire it. Now take the forarm off and I'll have to manually recock the ejector cams in the forarm befor it will go back on.

Are all your guns broken?

[Smoothebore]

If it's an underlifter with offset firing pins you purchased from me, then fire away, they will not break, I guarantee it.