Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Hi, Just wondering if any one has the knowledge as to how Parkers were manufactured, and the desire to share it here.
I am thinking details. How metal and wood arrived.
Example: A 6 inch block of metal came in, went to the drop forge, then hand shaped into a reciever, then it went off to the engravers table and... While this was going on a stock blank was machined or hand inlet.........
Well thats a lot to ask and my expectation is not that high. Thought someone might like to. I think most would like to read it.
How Parkers were manufactured
Threaded Mode