Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
This weekend I was measuring the internal bore diameters of two Remington Era Double Trap guns. I'm wondering if others can measure their Remington guns and tell me if this is common to all or just limited to Double Traps.
After the chamber and forcing cone, these two guns had an additional taper of about .015 to the final bore diameter. This taper was about 8" long which ended at a point about 12" from the breech. (See attached sketch).
Info on all Remington guns (Skeet, Trap, Game) wanted for possible PP article.
Extra Internal Bore Taper - Remington Era
Threaded Mode