Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Recently we picked up all of the double gun parts from Bachelders when they closed and one set of barrels in the lot was an 0 frame, 20ga GH with a blown tube. Measured with calipers and a wall thickness gauge and it was only about .010"-.012" at the blowout.
The opposite tube was .032" in the same spot and both bores measured .622" so I don't believe the blown barrel was back bored. This set will go on display in our front showroom as a good reminder to check the wall thickness whenever possible!
Measurement above the blowout
Opposite tube measured about .032"
__________________
Channing Will
Will Bros. Restoration
The Following 5 Users Say Thank You to Channing Will For Your Post:
Thin wall thickness
Threaded Mode