Quote:
Originally Posted by Aaron Beck
3. Any remaining "setback" is taken off the breech face which will likely result in the dolls head also being dressed a bit.
|
No, that's where you get into trouble. Just look at the end of a set of barrels to see all the surfaces that would be impacted.
You were doing good, with 1 and 2. Just keep smoking and removing metal from the hook until you get a good closure. The last .0005"-.001" you should be down to 1000 grit, or even crocus cloth. I like crocus cloth because you'll end up with about a 16 micro inch finish.
I can't think of any situation where you would alter any surface at the rear of the barrels. The fitters at Parker went to great lengths to get a perfect fit between the receiver and the barrels. Doing so would affect the dolls head, chamber rim depth, recoil bearing surface of the back lug, and fore end fit.
Threaded Mode