Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
I could set MEC Bar up in my half Bridgeport size Rockwell mill but am better at boring on the lathe . I use the mill to tune powder drops on brass fixed rotor bonanza pistol measures. There clean the hole up with an end mill Adjust charge with depth measured with a indicator, rotors no longer available buy small ones off eBay & alter to suit
Threaded Mode