GH 16 gauge
I'm considering the purchase of a very early G grade, 1 frame, 16 ga, with two sets of barrels both damascus, 30" (two beads) and 26" (one bead). Barrels are not pitted or dented and look to be a candidate for low pressure 2 1/2" loads. The wood is in good shape (no cracks or gouges) with plenty of finish, DHBP with engraved and timed screws. Engraving is sharp and some case colors, screws are timed and not buggered. Only one forearm which fits the 30" barrel and won't close on the 26" barrel. Action is tight. Some figure is visible on the barrels, which I was thinking of having refinished as per European tradition (probable cost aound $1,000). Replacing the forearm is likely to be expensive. Gun comes in a fitted case. Should I pursue this and any guidance on what I should set as a spending limit? Thanks very much for your advice.
|
Threaded Mode