Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Anyone run into this before? How did you correct it? Middle beads have small shanks, so I was considering a larger shank sight like https://www.gunpartscorp.com/products/529330 that would allow the hole to be centered with a needle file and drilled/reamed. The shank looks to be the same di. as a Lyman front bead.
I appreciate your sharing your solution if you have run into this before.
The Following User Says Thank You to jefferyconnor For Your Post:
Off center middle bead
Threaded Mode