Quote:
Originally Posted by Dean Romig
Why not turn a piece of brass to the correct diameter?
You may need to drill the hole in the stock deeper (wouldn't work in the case of the original hole being off center) to try to make up the difference in weight.... just a thought.
.
|
possible - or even a steel rod - but i would rather not drill deeper after repairing the crack
i may have found one source that sells the tungsten alloy in one inch rods-
the hole is two inches deep (5/8th in diameter) - two 1/2 inch diameter one inch long rods will be a little over four ounces - the lead was 3.5
not sure i am touch sensitive enough to notice an extra half ounce in a ten and a half pound gun
Threaded Mode