20 gauge 2 1/2 inch loads
Looking for advice on loading 20 Gauge for my Trojan with 2 1/2 inch chambers. Used the search function not much comes up. Might be asking it wrong.
Is the best bet buying a flat of 2 1/2 inch cartridges then reloading or is there a way to cut back 2 3/4 inch STS or AA's. Imagine I would move the center post on my MEC 600 down one hole. No 2 1/2 inch data on Hodgdon's site either.
Chambers measure about 2 5/8 so far have been shooting low pressure 2/34 inch hulls with 3/4 oz . Works fine just thought the right size would be better.
All advice appreciated
Bill
|
Threaded Mode