Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
The proper way to use the machinists scale to measure the chamber is to hold the barrels up to light while sliding the scale into the chamber, keeping the scale flat against the chamber wall. When the end of the chamber is reached the scale will lift as it enters the forcing cone allowing light to be seen beneath its edge. With practice this method will allow extremely close measurement of the chamber length.
Threaded Mode