If your loader has the short taper die you should be able to pull it out of the loader once the components are loaded and roll crimp , them place it back in and push the loaded round out ( maybe ) not sure if PW will push a roll crimped shell out without messing up the crimp , as they designed for fold crimping . It is worth a try , although it will be a slow process .
Or you can , as suggested before , resize with supersizer to the point where the hull will slide in the die freely , ad your components and slide the hull out by hand and roll crimp.
Or , as roll crimping does not reduce pressure enough to worry about , you could find a load that will fit with a fold crimp at the pressure you want and go that way , probably your best option .
Hope this helps
Mark
|
Threaded Mode