Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Could this broken pin base be drilled and a replacement shaft be pressed in or perhaps threaded for a workable repair? I want to the use the existing base to maintain the original integrity of the gun if possible. The tap hole could go .087 deep and not go through the side relief cut. Your recommendations are appreciated.
Thank you, Bruce
Help: Hemenway's Firing Pin
Threaded Mode