Quote:
Originally Posted by edgarspencer
That, in itself, was quite a chore, He's terrible about answering his phone. I found, in the past, that it's best to call him before 8am.
Sadly, Mitch Shultz, has retired, but we talked about honing, or opening chokes on composite barrels. His take on it was that from a practical point, there is no reason to avoid this type of work, and he believed the reluctance of others came down a liability concern, but not a metallurgical one.
|
I have been told the same about the physical work. Most people who do any of this have told me that the composite barrels are softer and much easier to bore or hone. I was told this by Skeets when I had the latest barrel bored.
Also, there is a question of boring vs honing. It takes a good inventory of reamers to cover the honing requirements, but the cost of significant removal can be half the job cost when paying for hones. From the smith standpoint I suspect that their preference would be to bore and then polish.
Threaded Mode