Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
I use 1"x3" pine which will actually measure closer to 2 1/2" wide. The top and bottom of the case are cut from 1/4" luan sub-flooring. I use a lot of finish screws about 1" long. I usually put a divider strip also screwed in from the top and bottom to keep the barrels separated from the back end of the gun.
Threaded Mode