Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
The bit in the mill/drill press is a very good route of all else fails. Worst that can happen in that scenario is that you break the bit.
The challenge at times can be holding the frame good and tight in the right spot.
Other than what you have done, I cannot recommend anything different. Sometimes they pop free just when you think you are out of luck. And sometimes you just hope not to push it too far.
__________________
B. Dudley
The Following User Says Thank You to Brian Dudley For Your Post:
Threaded Mode