I use mine to load 2 1/2 in with a roll crimp. First run your shell into the sizeing die. Dos"nt matter if it is a 2 1/2 or 2 3/4" seizing die. Next rotate the shell to the priming station and remove the primer and seat a new primer. Then rotate the case back to the sizing station and remove the case from the sizing die. Place the casing under the shot and powder tube and dispense the powder. next seat the wad and dump the shot. Place your over shot card and roll crimp in a drill press. The last four steps are completed with out support from the sleeve. Its much easier than it sounds. One little tip. I use a 45/70 empty case to help remove the primed case from the sizing die. Drop the empty 45/70 case in the empty shotgun hull and lower the handle on the press. The case takes up enough space in the shotgun hull to allow you to press out the empty shotgun hull. I load shells this way all the time.
|
Threaded Mode