|
 |
 |
|||||||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||||||
 |
 |
06-12-2015, 09:33 PM
|
#13 | ||||||
|
Well I think the gun has a new owner so we may see it again someday...
|
||||||
|
|
||||||
 |
 |
 |
|
|
|
06-12-2015, 09:35 PM
|
#14 | ||||||
|
Hopefully we find out it was salvageable and get a good Parker Pages article on it
|
||||||
|
|
|
||||||
|
|
|
|
To be continued...... | |
|
06-12-2015, 09:57 PM
|
#15 | ||||||
|
To be continued......
We will see how it works out and I will document progress. Thank You, again, Greg. I needed a retirement project!
Joe |
||||||
|
|
|
||||||
|
|
|
| The Following 3 Users Say Thank You to Joe Dreisch For Your Post: |
|
project | |
|
06-13-2015, 08:44 AM
|
#16 | ||||||
|
project
Good luck with it......should be fun......will be interested in your progress..
|
||||||
|
|
|
||||||
|
|
|
|
|
|
06-13-2015, 08:52 AM
|
#17 | ||||||
|
My 16 gauge 1 frame had similar ripples in the barrels and dale Edmonds got them out
|
||||||
|
|
|
||||||
|
|
|
|
|
|
06-13-2015, 09:01 AM
|
#18 | ||||||
|
Sometimes with barrels like these the temptation after tapping the irregularities as much as possible is to finally strike the exterior and hone the bores... Do not allow this to be done. You may end up with barrel walls that are too thin to be safe.
|
||||||
|
|
||||||
|
|
|
| The Following User Says Thank You to Dean Romig For Your Post: |
|
|
|
06-13-2015, 09:16 AM
|
#19 | ||||||
|
Dean is right.
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Mills Morrison For Your Post: |
|
|
|
06-13-2015, 11:14 AM
|
#20 | ||||||
|
Yeah, that's what I meant when I said they would need to be worked so much something would not be right when it was all over. I just don't see how a gun could get so many dents to start with....repeated carelessness I guess.
The bores were not too bad in terms of pitting and the chamber area looked fine, inside and out. But just so may dents on the tubes. |
||||||
|
|
|
||||||
|
|
|
 |
|
|
Linear Mode
