Help needed

[Larry Welch]

I have an old parker that Mr Graham has checked out and made some repairs. Upon his examination the right barrel is thin right in front of the chamber. It is a 1 1/2, 12 guage. His advice was to not shoot it, in that barrel. I am not a safe queen type of guy, any advice on where I may find a set of 1 1/2 barrels? Or would I be better off sending it to have tubes put in it for 20 guage? It is to nice to just sit around and look pretty.

[Mills]

That is a bad place for thin barrel walls. I have a 16 with similar issue and Briley put 28 gauge short tubes with great results.

[B. Dudley]

What are the measurements of the barrel?

[George Lang]

What would a minimum wall thickness in front of the chambers be for a 12 gauge, any frame size?

[Larry Welch]

Dudley, I don't remember exactly, I just remember he said he wouldn't even suggest rst loads out of the right barrel.

[peter brown]

I disassembled my DHE for some stock work . Upon reassembly I cannot get forearm back on. Everything else seems right ? Help

[Bruce P Bruner]

It’s advisable to start a new thread with your new topic. The home page has lots of helpful information, such as pertaining to your inquiry. Easy fix:

[Dean Romig]

My WAG is about 0.0115" as a minimum... or should I say that for my own personally safety I wouldn't shoot an old sxs that had less than 0.0110" at the juncture of the chamber and the beginning of the forcing cone.

I have a Damascus 0-frame 16 gauge GHE that Oscar Gaddy measured at 0.0063" and wrote to me that it "is probably safe to shoot with pressures of less than 7,500 psi."





.

[edgarspencer]

Originally Posted by Dean Romig

My WAG is about 0.0115" as a minimum... or should I say that for my own personally safety I wouldn't shoot an old sxs that had less than 0.0110" at the juncture of the chamber and the beginning of the forcing cone.

I have a Damascus 0-frame 16 gauge GHE that Oscar Gaddy measured at 0.0063" and wrote to me that it "is probably safe to shoot with pressures of less than 7,500 psi."

Are you sure about your decimals? I can't believe anyone would suggest six thous safe to shoot.

[Larry Welch]

I ain't 100% sure but if I remember I think.0030. It had been refinished and he said they took too much out while doing so. I may wind up just getting a set of tubes from briley, but I would love to find a set of barrels and have them fitted.