|
 |
 |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
 |
08-10-2024, 07:49 PM
|
#3 | ||||||
|
A Parker Reproduction case or an Abercrombie and Fitch VC case. One reasonable if you can find it, the other off the charts for cost.
|
||||||
|
|
||||||
 |
 |
 |
| The Following User Says Thank You to Bill Murphy For Your Post: |
|
|
|
08-10-2024, 09:50 PM
|
#4 | ||||||
|
The Repro Case and Cover is the way to go.
Then go on ebay and buy one of the Parker Bros leather labels sold by a seller in the Ukraine. The label will completely cover the Repro label and they look great. Bob Juewicz |
||||||
|
|
|
||||||
|
|
|
| The Following 4 Users Say Thank You to Bob Jurewicz For Your Post: |
|
|
|
08-11-2024, 09:19 AM
|
#5 | ||||||
|
I agree with posts above if you are looking for a stylish case. However, if you do serious travel by air, water or land then I would recommend a modern molded locking case (TSA approved if flying.) There are dozens of youtube videos comparing and testing the many brands (Apache, Pelican, Nanuk, Negrini.) The cost can be less than $100 to almost $1000. They are all function and no style compared to the ones mentioned in earlier posts but will protect your Parkers from serious abuse.
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Chris Pope For Your Post: |
|
|
|
08-12-2024, 12:30 AM
|
#6 | ||||||
|
Thanks to all of you for your advice. I plan on getting both a Parker Repro case and a TSA approved travel case as well. Dennis, if your Parker Reproduction case is specifically made for a 20ga. with 26” barrels and has the lock key, I’ll take it. Otherwise, I might look for a bit more. Thanks again.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
08-12-2024, 10:45 AM
|
#7 | ||||||
|
Kevin,
I'm not sure any case is "made specifically for a 20 gauge". As far as I know, Parker Reproduction cases were made to fit 20 and 28 gauge guns and the snap caps for either will fit. Mine does have a key. Someone chime in please if I'm wrong.
__________________
Nature and four-leggers are God's prescription for what ails the soul. - DWM 
|
||||||
|
|
|
||||||
|
|
|
|
|
|
08-12-2024, 12:48 PM
|
#8 | ||||||
|
You may be right, Dennis. I’ve been looking into this a lot and found one on a Parker Repro case that stated the barrel length it can accommodate is 26” with the block in place and 28” without it.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
08-12-2024, 01:05 PM
|
#9 | ||||||
|
My case is for 26" or shorter barrels. It has no block to remove.
__________________
Nature and four-leggers are God's prescription for what ails the soul. - DWM
|
||||||
|
|
|
||||||
|
|
|
|
|
|
08-12-2024, 01:11 PM
|
#10 | ||||||
|
Perfect! If it’s for 20/28ga., I’ll take it.
|
||||||
|
|
|
||||||
|
|
|
 |
|
|
Hybrid Mode