Case Color Lacquer

Steve Hodges · 01-12-2018, 10:47 AM

Has anyone used Connecticut Shotguns Case Color Lacquer to help protect the case colors on a Reproduction? If so, what were your experiences with it and do you think it helps? Thanks, Steve

Wild Skies · 01-12-2018, 11:16 AM

I have a bottle of it and have applied it to a couple of my guns. It does impart an amber colored hue to the colors. It probably helps protect. If you do not care for the amber-look it's easily removed with acetone (finger nail polish remover) without damaging the original colors.

Richard Flanders · 01-13-2018, 10:53 AM

I use hardware store spray lacquer with good results. No issues to date. Wears well. No discoloration. Works for me. I think you could also use IBIZ wax, which is supposedly pure carnuba and contains no abrasives and which is very hard. That's what I use on all my damascus bbls with excellent results.

B. Dudley · 01-13-2018, 12:14 PM

It is basically shellac.

J. A. EARLY · 01-13-2018, 08:15 PM

I use clear Brushing Laquer, purchased from Lowes. Only $10 for a quart. That will do hundreds of guns plus other stuff. Smooths out nicely with a small artist brush. Use on trigger guard also if bluing is good. When you need to redo, you have to clean off all of the old because the new will dissolve the old and cause streaking.

WmRike · 01-14-2018, 12:02 PM

I use a light coat of rattle-can lacquer. Quick and easy, no brush marks.

Keavin Nelson · 01-15-2018, 09:28 PM

How do keep it off the wood, wouldn't go well on an oil finish?..

WmRike · 01-17-2018, 12:50 PM

Done properly, the wood comes off, and screws, pins, and top lever come out. Failing that, it's probably best to use a brush and keep the stuff away from wood/pins/screws. I don't know what you would do around the top lever. Ideas, anyone?

Wild Skies · 01-17-2018, 05:04 PM

If you can paint by numbers you can apply Case Color Lacquer with a brush without removing the wood. If you can't, then have a small cotton rag handy and wipe the lacquer off where you got a little of it on the wood. It's as simple as that.

Why risk damage by removing the wood to spray when brushing without risk is so easy that anyone can do it with perfect results?

Randy Roberts · 02-13-2020, 02:55 PM

Concerning the application of lacquer to preserve colors would mineral spirits be acceptable as a degreaser prior to application? Also how many coats of lacquer do you typically apply ?