Visit Brian Dudley's homepage! | |
01-30-2018, 10:24 PM | #3 | ||||||
|
Take your forend apart and snap the forend iron back on the barrels by itself and see how snug the locking toggle is .
Chris |
||||||
01-30-2018, 10:32 PM | #4 | ||||||
|
Tough to do on a DH as everything depends on the wood separating the opening lever from the forend iron. The lever only takes the slightest pull on it to get the forend off. Trying to figure where the problem is; the lever?, the flat steel lever spring?, the toggle that engages the barrel lug?, the barrel lug?
The forend locks well on the barrels and lug. You can't pull it off. But when shot the recoil causes it to disengage. |
||||||
01-30-2018, 10:50 PM | #5 | ||||||
|
The forend loop (forend lug on the barrels) probably needs material added and then dressed down for a perfect fit, forcing the forend rearward a few thousandths.
.
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
||||||
The Following 2 Users Say Thank You to Dean Romig For Your Post: |
01-30-2018, 11:43 PM | #6 | ||||||
|
The lever spring only returns the lever after being lifted. You can actually remove the lever assembly and put the forend back on the barrels and manually push the toggle under the lug. If it's not snug, then you could add material under the lug to tighten toggle contact. I've seemed the lug peened to achieve this. Lol
|
||||||
The Following User Says Thank You to Chris Robenalt For Your Post: |
03-13-2018, 02:10 PM | #7 | |||||||
|
Quote:
|
|||||||
03-13-2018, 07:31 PM | #8 | ||||||
|
On my DH the forend is on there as tight as it can be. One cannot pull it off once on. However, the slightest pull on the forend lever releases it, so Edgar is correct. That is why taking the wood off and just putting the forend iron on probably won't tell me anything in my opinion.
The inertia of the recoil moves the lever enough to disconnect the forend after firing. |
||||||
03-13-2018, 08:45 AM | #9 | ||||||
|
HI. I have a DH 2 barrel set doing the same thing - forearm comes off when shot. Who would you recommend for the repair? I have had Turnbull do some work on an LC Smith before with good results. Funny thing is the forearm comes off easily on the 16 gauge barrels, but is super tight on the 20 gauge barrels.
__________________
A Dog, A Gun, and Time enough! George Bird Evans |
||||||
01-31-2018, 06:18 AM | #10 | ||||||
|
Dont peen any part of a Parker unless you have a desire to rapidly diminish its value.
.
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
||||||
The Following 4 Users Say Thank You to Dean Romig For Your Post: |
|
|