|
01-19-2012, 06:05 AM | #3 | ||||||
|
What guage is? Is there a 1 stamped on the barrel lug? I don't know but they must of took a little care, the reciever is not rusted. Is the extractor 1 piece or 2. Are the barrels pitted bad? Somebody shot it a lot to wear that buttplate. I like the ol gun bet he put a lot of meals on the table. To him it was just a fine tool to feed his family. Speculation on my part of course.
__________________
Father, will I be able to be brave when I am afraid? Child, that is the only time one can be brave. |
||||||
01-19-2012, 07:57 AM | #4 | ||||||
|
This is a 12 ga and the extractor is 2 piece. The last time I tried to remove the barrels I could not get them off so I'm not sure of the stamp on the lug at this point. I'll try that one again. Overall the barrels apear in good shape with only very minor pitting on the outside. My mother-in-law says as long as she can remember this gun stood in the corner of her fathers room and being a farmer I've no doubt the gun was well used.
We do plan on have a good gunsmith inspect the gum. |
||||||
01-19-2012, 06:19 PM | #5 | ||||||
|
Hello Bob: SN 67621 is not in "THE BOOK" but your Grandfather's gun was made in 1891 and is somewhat rare with automatic ejectors. I would suggest ordering a research letter from Mark Conrad which should give you some more information. In any event please keep the gun in the family to preserve it's history.
Best Regards, George |
||||||
01-21-2012, 06:01 AM | #6 | ||||||
|
Bob, This gun speaks volumes just by looking at it. Imagine a cold morning and your grandfather hunting with this old girl, and maybe just maybe that dent in the barrel was from the fence post as he was crossing over to the other side and maybe that mark in the stock came about as he was sitting down at his favorite spot and it was laid on an unseen rock. Think about this every time you pick her up and she will talk to you!
|
||||||
The Following 2 Users Say Thank You to Gary Carmichael Sr For Your Post: |
|
|