D4 4 iron Damascus?

[Eddie Kay]

Is the D4 4 iron Turkish Damascus barrel's considered stronger than other Damascus grade's? Iv'e been shooting High Gun & Perfect Pattern powder at approx. 5000 psi.

[Dean Romig]

Not at all. They are the same strength and 5k psi is fine for them as long as the wall thickness is sufficient with no serious dents or pits.





.

[Drew Hause]

Thanks to Dave Suponski we tested one sample. Scroll down about 1/2 way here
https://docs.google.com/document/d/1...U/edit?tab=t.0

Crolle Damascus
2 Crescent No. 8 Knickerbocker 3 Rod Oxford (undoubtedly Belgian sourced), c. 1905 – 53,000 and 56,500 psi.
1 Wm. Powell Birmingham 3 Rod Oxford – 54,500 psi
1 Unknown English maker 3 Rod Oxford – 49,000 psi
1 Unknown source 3 Rod Oxford – 54,000 psi
1 Parker D4 4 Rod Turkish – 57,500 psi
1 Parker DD 6 Rod Turkish – 55,000 psi


For comparison Parker Titanic, post-WWI Vulcan, and Trojan steels were essentially the same; AISI 1030 and 1035 medium carbon steels with a tensile strength of 76,000 - 85,000 psi.

[Eddie Kay]

Appreciate it, Thank you

[Bob Jurewicz]

What "Quality Damascus" is this?
Bob Jurewicz

[Eddie Kay]

[Drew Hause]

DD is usually 6 Iron "Turkish" Bob



The arrows indicate the ribband edge welds. The scrolls are typically compressed with the edges are 'jumped' and the weld line is straight; not the wavy 'zipper' weld down the middle of the other scrolls

[Dean Romig]

DD is usually only seen on Grade-5 and higher Parkers as original barrels. I know of a Grade-2 hammer gun with two sets of Damascus barrels, one of them is DD Damascus and is not original to the gun.





.