Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
I will try to post a photo later , but I am challenged in that area. Start with a 3/4 in. dowel , drill 3-4 small holes at about a 15 degree angle and drive an exacto blade into it at approx 2-1/2 in. up from the base adjust with spacers and thumb tacks in butt if needed. There is a thread here some where explaining it. My first one was made by Scott Kitteredge and I have made them for 20 and 410. I will look for that thread and maybe Scott or Pete Lester will have some information.
The Following User Says Thank You to Daniel Carter For Your Post:
Threaded Mode