|
 |
 |
|||||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||||
 |
 |
01-18-2013, 10:13 PM
|
#3 | ||||||
|
rounds worth there have been a set or two over the years on the internet...even our silent auction had a lifter 8 ga in the rough...i believe it to be possible to pirate one of those really thich ten ga spanish guns and take the barrels and bore to 8 ga...this has been done...then i would get a ten ga parker barrels and use all the hardware off barrels and mate to spanish barrels...just a suggestion but it could be done and if you have a machinest friend it would not cost a arm and a leg... is you 6 frame ten a hammer or hammerless gun.... charlie
|
||||||
|
|
||||||
 |
 |
 |
| The Following User Says Thank You to charlie cleveland For Your Post: |
|
|
|
01-18-2013, 11:35 PM
|
#4 | ||||||
|
Charlie, my 6 frame gun is a hammerless 10 gauge. The unstruck weight of the barrels is 8 and 4.
__________________
GMC(SW)-USN, Retired 'Earnest Will' 'Desert Shield' 'Desert Storm' 'Southern Watch' |
||||||
|
|
|
||||||
|
|
|
|
|
|
01-19-2013, 11:21 AM
|
#5 | ||||||
|
your ten ga barrels weigh the same as my old 8 ga lifter barrels.. 8 4 charlie
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to charlie cleveland For Your Post: |
|
|
|
01-19-2013, 01:43 PM
|
#6 | |||||||
|
Quote:
|
|||||||
|
|
|
|||||||
|
|
|
| The Following User Says Thank You to Eric Eis For Your Post: |
|
|
|
01-23-2013, 02:33 AM
|
#7 | ||||||
|
Charlie I think you're way off base on the whole idea of the Spanish barrels. If you could find somebody to take on the project it would cost thousands.
Destry
__________________
I was as virtuously given as a gentleman need to be; virtuous enough; swore little; diced not above seven times a week; went to a bawdy-house once in a quarter--of an hour; paid money that I borrowed, three of four times; lived well and in good compass: and now I live out of all order, out of all compass. Falstaff - Henry IV |
||||||
|
|
|
||||||
|
|
|
|
|
|
01-23-2013, 09:13 AM
|
#8 | ||||||
|
i could be off the price i guess but there are people out there with the skills that could do this... charlie
|
||||||
|
|
|
||||||
|
|
|
|
|
|
01-23-2013, 09:16 AM
|
#9 | ||||||
|
The first thing that has to match exactly when using those Spanish barrels is the pin separation. The chance of that matching is pretty slim.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
01-23-2013, 10:02 AM
|
#10 | ||||||
|
I was thinking of trying to find an orphan set of barrels for my 8 gauge project, but this thread confirmed my suspicions about it being impossible.
By the way, a 6 frame 10 gauge would be cool. I hope Roundsworth has the whole gun. |
||||||
|
|
|
||||||
|
|
|
 |
|
|
Linear Mode
