Parker BHE barrel and water table original?

[Mark Luitjen]

I'm seriously considering a BHE but have some questions regarding the gun. First, after looking at dozens of guns on Guns International and Gun Broker as well as a couple of hours on our Forum, every BH I've seen has an engraved band where the barrel meets the action. This gun does not have the engraved band. Also, there is a cut on the rib about two inches in front of the doll's head. Lastly, the water table is engine turned and I don't know if that is an option from the factory or if it was done later. The gun appears to be a legitimate BHE and the price is not unreasonable, but I worry that there may be some issues as to the originality which could affect the value. I have several Parkers from Trojan, VH, VHE, PHE, GHE and SC and am hoping to add a true high grade to the collection but would appreciate some guidance because even though the price seems reasonable, its still a lot of money.

[J. Scott Hanes]

What is the serial number? What markings are on the water table?

[Reggie B]

Sounds like anything but an original Parker BH.

[Craig Larter]

Originally Posted by Reggie Bishop

Sounds like anything but an original Parker BH.

Agree

[Bill Murphy]

Sorry, but you have to provide pictures to get a good opinion of what you are describing.

[Dean Romig]

If the “cut on the rib” is something that you can catch your thumbnail on and it’s quite visible I would suggest at the minimum that the barrels have been worked on and poorly refinished… that or possibly replacement barrels.

What’s the serial number?
How about a pic of the markings on the barrel flats.





.

[Mark Luitjen]

The serial number is 152347. It appears that it was re-barreled with a Titanic steel D grade barrel, rather than an Acme Steel barrel. The same serial number is on the barrel but there is a 3 on the barrel flat. The asking price was $9K but I brought these issues to their attention and it is now priced at 5K. Is it possible that the barrels were originally Damascus and it was re-barreled with a Grade 3 barrel, or was it more likely cobbed together? Is it worth the asking price in your opinion? I haven't figured out how to send pics yet but am working on it.

[edgarspencer]

Originally Posted by Mark Luitjen

Is it worth the asking price in your opinion? .

Yes, and then some. It sounds like a gun which went to Remington and was fitted with Grade 3 barrels. The fit at the dolls head is quite good and the rib extension joint isn't any worse than a lot of guns out there.

[Larry the Gun Guy]

And the roll pin has been reversed, probably for wear. And you can see the plugged hole in the bottom rib.

[Dean Hanson]

NIB. Those should have been fluid steel barrels (Acme) with that serial #, unless otherwise requested. Do all the serial numbers match?