Not quite a basket case, but close. Need a good Parker Gunsmith

[stevenjay]

I picked a Parker VH Grade made in 1906 about 10 years ago for cheap, real cheap. It had some garage gunsmithing done on it, a bad carving job on the butt stock which I'd like to replace and it looks like some one even used an easy out on one of the screws. Now the good part, It looks like all the parts are there, the bores are nice and shiney and when close the barrels are tight against the action. I black powder hunt with other double classics, a L. C. Smith, a Fulton and a Model 99 Forehand Damascus hammer Double (the most fun). I would love to get the Parker up and running. Can anyone recommend a good Parker gunsmith? Here are some pictures of the Parker. Thanks, Steve

[George Lander]

Jim Kelly, Darlington Gun Works, Darlington, South Carolina Phone (843) 893-3831

Best Regards, George

[OH Osthaus]

you could contact Brian Dudley on this board- search his name to see some of his work

but something to think about- if its a 12 ga you can be under water on the value of a VH real quick

[Dean Romig]

Be careful - the stock doesn't appear to be original - there's no evidence of a shield in the bottom of the stock.





.

[stevenjay]

[QUOTE=Dean Romig;197216]Be careful - the stock doesn't appear to be original - there's no evidence of a shield in the bottom of the stock.


Hi Dean, You are right and I stand corrected. I took a real hard look at the butt stock and thought it does seem to be a Parker stock off of some model it is not the right one for this shot gun. The numbers I mistook for matching the guns serial number are not. When I took off the butt stock and upon closer examination you can see some wood shims, poor relief cuts and even some filler. So...I have a lot to learn. Steve

[GH-16]

Keep in mind. A stock replacement can be somewhere around $2000.00 plus or minus a few hundred either way. The trigger plate screws need replaced & I see the top tang screw is backed out some & you don't know what the internals look like until it's opened up.

Over all this one could be like a boat. "A big hole in the water to throw you're money"

I'm not saying don't do the work, I am saying: Have your eye's wide open going in.

[Chris T.]

At least the lever is still to the right

[Dean Romig]

Yeah but that screw is holding it there...






.

[Chris T.]

Originally Posted by Dean Romig

Yeah but that screw is holding it there...
.

I know, that was the funny part. Just trying to lighten the mood....seems like some of the forums I frequent have been running hot lately.

[Dean Romig]

sorry - duplicate post.






.