Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
I was looking at Ron Scores album and ran across these images of the receiver of his GH(?) grade 12ga on a 1/2 frame. Interesting gun, what with the extra engraving and checkering. But that is not what caught my attention. Observe in the picture the slots cut in the joint end of the receiver, and the pins that are on each side near the pivot pin. I have seen this before but I don't understand why this feature was used. Any help?
Receiver variation question
Threaded Mode