I’d like to share some pics of my “double barrel” case trimmer for 2-7/8” Short Tens. Trimmer was made from the chamber end of an old 10-gauge barrel. In the past I shortened 3-1/2” 10-gauge hulls by holding them on a mandrel and spinning against a sharp utility knife blade that indexed from the base wad. That worked OK but it seems the base wads aren’t that uniform in height and sometimes the cutting blade runs off. Thus the cut 2-7/8” hulls varied a little more in length than I liked. This new trimmer indexes the 2.875" cut from the rim of the hull. I’m sure someone will ask me what this barrel came off. Answer is: I don’t know, the barrel legend is hard to read. I bought the barrel for 15 bucks at the Allentown gun show two weeks ago, Most of the pics here are self explanatory.
Barrel cut to rough length with a hack saw
Filed smooth, before stub was set up on the mill and machined to exact length
Barrel stub held in the bench vice and new Remington 3-1/2” cases in place. These are the olive green 3-1/2" 10-gauge hulls sold by Precision Reloading.
Back end showing large wing nut to hold hulls from spinning while making the cut. Extractor stem hole has been dilled & tapped for a ¼-20 stud
That’s a craft saw with an ultra fine tooth blade.
Cut is complete and hulls were finished-trimmed with a long utility knife blade.
Here’s all the goodies.
Ten cases took about 4 minutes to make. Cases vary only about .003" in length.