|
 |
 |
||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||
 |
 |
10-13-2013, 10:25 AM
|
#3 | ||||||
|
And the letter page also says no available information
BUT PLEASE DON'T LET THAT STOP YOU FROM POSTING PICTURES come on - its a 0 frame 16 - what more do you want - Angel is hitting refresh every minute.
__________________
"If there is a heaven it must have thinning aspen gold, and flighting woodcock, and a bird dog" GBE |
||||||
|
|
||||||
 |
 |
 |
|
|
|
10-13-2013, 12:45 PM
|
#4 | ||||||
|
If Gman doesn't post pics of his 0-Frame 16, I might have to post some pics of mine.
It will have to be in the Hammer Gun forum though. |
||||||
|
|
|
||||||
|
|
|
|
|
|
10-13-2013, 05:24 PM
|
#5 | ||||||
|
The gun has been used but is tight on the face and shoots like a 16 0 frame should. Its a pleasure. Tight chokes pattern right on. the gun has seen too much oil over the years and must have a full cleaning and going through.It locks up real tight with no play whatsoever but the lever is left of center and I hope I can get that some attention. I have a P grade O frame 16 Twist barrel that I bought this summer from a PGCA member that I really like but don't want to take it in the duck boat so I was looking for another. I am going to shoot some ducks before I send it to someone and am contemplating having the wood looked into as it has more oil than I have experienced. Id be interested i any feed back regarding the lever fix or the wood. sorry the pictures below are not of better quality. the last picture are my two ) frame 16s.
|
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to Eric Grims For Your Post: |
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode