Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Has anyone had any good success with replacing the Joint Roll (the round washer piece that goes over the hinge pin)? I am curious if they require a lot of fitting. Also, if you have a gun that is off face and you replace the Joint Roll, can this make the gun tight? I have heard that it can go both ways, i.e. sometimes the gun is looser. Finally on extractor guns is the Joint Roll the same size for all frame sizes?
Re-Jointing
Threaded Mode