Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
I needed a new spring for my 12ga Grade 0 hammer gun. This is what I found at True Value. Anything smaller than 7/32 and it will not fit on the firing pin anything bigger and the firing pin chamber will not allow the spring to be in line with the firing pin hole
You can adjust the strength by shortening or lengthing the length of the spring. I've been told by Dewey Vicknair that the strength of the return is not critical, just so that it fully retracts the firing pin.
Source for offset firing pin springs
Threaded Mode