Paul, thanks for the tip on reloading Remington 28ga. hulls. The drill bit clears the primer hole but hits the plastic so it doesn't go completely through. Drilled out the plastic and the primers seated no problem. It adds 2 steps to the reloading process (knocking out the primer, and reaming the hole with the drill), then reloading. I'll do this on the Remington hulls I have, then switch to Winchester or Federal. I don't have any once fired 20ga. Gun Clubs to check but I suspect they are the same due to my problems loading primers in them. I did check once fired Remington Premier 12ga. hulls and they also will not allow the drill bit to go completely through the primer pocket. Not a problem as I only load Federal in 12ga.
|
Threaded Mode