|
 |
 |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
 |
03-12-2016, 03:44 PM
|
#3 | ||||||
|
That's what I was looking for. Thanks
|
||||||
|
|
||||||
 |
 |
 |
| The Following User Says Thank You to Gary Cripps For Your Post: |
|
|
|
03-12-2016, 05:11 PM
|
#4 | ||||||
|
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to edgarspencer For Your Post: |
|
|
|
03-12-2016, 06:33 PM
|
#5 | ||||||
|
Is your press specifically designed for 2 1/2 inch shells?. MEC will make you a 2/1/2 inch press. Unless your going to shoot it a lot RST makes a 2 1/2 inch low pressure 28 shell.
__________________
There is no hunting like the hunting of man, and those who have hunted armed men long enough and liked it, never care for anything else thereafter...Earnest Hemingway |
||||||
|
|
|
||||||
|
|
|
|
|
|
03-13-2016, 07:42 AM
|
#6 | ||||||
|
When I have a lot to cut I use a sliding table on my table saw. 4 at a time.
Jig is simple want a photo let me know. William |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to William Davis For Your Post: |
|
|
|
03-13-2016, 02:40 PM
|
#7 | |||||||
|
Quote:
|
|||||||
|
|
|
|||||||
|
|
|
|
|
|
03-13-2016, 04:55 PM
|
#8 | ||||||
|
I also use a table saw for both paper and plastic. Here's how simple it is. Take a two foot long section of 2X4 and trim it so that it is 2 inches wide. Measure the diameter of the gauge you would like to trim. Drill holes through the 2X4 of that diameter ( I have 10 holes in mine so I can trim 10 hulls at a time ). Insert the hulls through the 2X4 and adjust your rip bar to the length of hull you want, then run the 2X4 with the shells in it very slowly thru the blade. Use a blade with very fine teeth for the smoothest cut.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
03-13-2016, 06:40 PM
|
#9 | ||||||
|
I have had MEC make me their 9000 model for 2.5 inch 16 & 20ga. If you shoot a lot the 600Jr gets old real quick.
__________________
There is no hunting like the hunting of man, and those who have hunted armed men long enough and liked it, never care for anything else thereafter...Earnest Hemingway |
||||||
|
|
|
||||||
|
|
|
|
|
|
03-13-2016, 07:54 PM
|
#10 | ||||||
|
I made a jig and trim the hulls down using my band saw. Work pretty good.
|
||||||
|
|
|
||||||
|
|
|
 |
|
|
Linear Mode
