Trigger question

[Chaz Cole]

Just wondering how the triggers should feel? There seems to be a lot of slack in both of the triggers on a 16ga vh I just got. This is my first Parker so I'm unsure.

[Parkerman]

Do your triggers "creep" or is it just slackness?

[Pa SxS]

All my Parker's have no creep or slack. It's like breaking a pane of glass.

[J. A. EARLY]

What you may have is a missing or reversed spring. There is a small spring in there that keeps tension on the two triggers to keep them in contact with the sears. Is this the slack you speak of?

Go to the Home Page, on the left Technical Information and see part number 10 in the diagram. Also look at the trigger plate behind your triggers and there should be a flush screw coming to the bottom of the floor plate from inside the gun. If you just see a hole, the spring and screw are missing. If there is a screw apparent, the spring may have been put in reversed putting downward pressure on the triggers causing slack between them and the sears. A common reassembly problem for someone working on a gun that just does not know.

With the gun upside down and safety off and gun unloaded obviously, move the trigger as if pulling it until it contacts the sear. Let go and if it springs back up, the spring is reversed.

Very easily corrected in ten minutes if it is reversed.

[B. Dudley]

Or a broken trigger spring. Could be missing, but likely broken.

[wayne goerres]

Easily fixed if you have the proper screw drivers.

[Chaz Cole]

Originally Posted by Jerry Harlow

What you may have is a missing or reversed spring. There is a small spring in there that keeps tension on the two triggers to keep them in contact with the sears. Is this the slack you speak of?

Go to the Home Page, on the left Technical Information and see part number 10 in the diagram. Also look at the trigger plate behind your triggers and there should be a flush screw coming to the bottom of the floor plate from inside the gun. If you just see a hole, the spring and screw are missing. If there is a screw apparent, the spring may have been put in reversed putting downward pressure on the triggers causing slack between them and the sears. A common reassembly problem for someone working on a gun that just does not know.

With the gun upside down and safety off and gun unloaded obviously, move the trigger as if pulling it until it contacts the sear. Let go and if it springs back up, the spring is reversed.

Very easily corrected in ten minutes if it is reversed.

I tried holding it upside down and the trigger did spring back up. How do you go about reversing the spring?

[J. A. EARLY]

You have to remove the trigger guard and then the floor plate to get to it. You need correctly sized screwdriver bits so you do not mar your screws.

Brian Dudley has put together a step by step procedure you can find on the home page; number 35 under Parker FAQs.