![]() |
![]() |
![]() |
||||||||||||||||||||||||||||||||||||||
Visit Brian Dudley's homepage! | |
![]() |
![]() |
![]() |
#3 | ||||||
|
![]()
Thanks Dudley. Is this a case of SOL, or are there persons who can either make a new screw or fit an existing one? Is it even worth the cost if I can find someone to do the work? I can live with the two originals that are marred, but would love to have something that looks less out of place for the front screw.
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#4 | ||||||
|
![]()
Those look pretty bad, but, on occasion, it's possible to peen the distorted slot edge back down. It doesn't make it look great, just passable to ok. a 1/4" Starrett punch works ok.
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following 2 Users Say Thank You to edgarspencer For Your Post: |
![]() |
![]() |
![]() |
#5 | ||||||
|
![]()
I am looking for a set of new / replacement receiver screws that can be fitted to a hammerless 12ga. The screws used to be available from Connecticut Shotgun, but seam to have dried up.
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#6 | ||||||
|
![]()
PM Tom Carter on this site or call him at 1-843-546-0609 or 1-843-344-3315
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following 3 Users Say Thank You to Jim DiSpagno For Your Post: |
![]() |
![]() |
![]() |
#7 | ||||||
|
![]()
Thank you Jim
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#8 | ||||||
|
![]()
Let us know how that works out for you.
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
|
|