|
04-16-2016, 10:16 AM | #3 | ||||||
|
Is it possible that the seback experienced when the gun is fired could cause the malleable lead rod to deform into a shorter, larger diameter piece, and that could cause the splitting?
__________________
"Striving to become the man my dog thinks I am" |
||||||
04-16-2016, 10:18 AM | #4 | ||||||
|
possible , but at least in this case- the plug is not loose and completely fills the hole
__________________
"If there is a heaven it must have thinning aspen gold, and flighting woodcock, and a bird dog" GBE |
||||||
04-16-2016, 10:31 AM | #5 | ||||||
|
As I visualize it the plug would drift aft, and a void would be created in front of the plug. You couldn't see it. If my half-baked idea is close to right, the plug would not be loose. It would have swollen and would be jammed so tightly that it cause a wood split.
__________________
"Striving to become the man my dog thinks I am" |
||||||
04-16-2016, 01:55 PM | #6 | ||||||
|
http://www.mcmaster.com/#tungsten-alloys/=120cdyn
"High strength durable tungsten" on this page is what you'd want. Not cheap, but not out of this world....$178 for 8" of 3/4 " diameter bar. |
||||||
04-16-2016, 03:00 PM | #7 | ||||||
|
|
||||||
04-16-2016, 04:57 PM | #8 | ||||||
|
I believe it is as Dean and some others have said. Moisture over time corrodes lead into lead oxide or lead carbonate. This is less dense than lead itself and increases the volume as corrosion occurs. In time this will split the wood. I am no chemist, but after 100 years I would think that even the low moisture content of the wood itself would be enough to do this. Of course many guns have their wood exposed to considerable moisture helping the process along. It does not happen overnight.
|
||||||
The Following User Says Thank You to Eric Estes For Your Post: |
04-16-2016, 05:16 PM | #9 | ||||||
|
Here are my thoughts. Lead expands when heated and contracts when cooled. Lead coefficient of expansion in inches per inch of material per degree of F is 0.0000151. Lead melts at 621 degrees. So if the lead added to a hole drilled in a stock was one inch in diameter it would actually contract .008 when it cools. Resulting in just a few thousandths gap around the lead rod. I think my math is correct possibly not.
After the initial cool down the temperature expansion and contraction would be quite a bit less in the average hunting and storage environment. I think Dean is correct in corrosion could result in expansion and cause splitting. I also think the wood expanding with humidity or wood constricting due drying out may result in the splitting. If my think is correct, which it might not be, then any heavy metal would resut in the same possibility of cracking the stock. |
||||||
The Following User Says Thank You to Phillip Carr For Your Post: |
04-16-2016, 06:36 PM | #10 | ||||||
|
Knot and wood filler in my old 16ga Stevens 5100, in the wrist no less! I guess you can expect such in a Stevens, but it's still in one piece so far...
__________________
It ain't what you don't know that gets you into trouble. It's what you know for sure that just ain't so. - Mark Twain. |
||||||
|
|