|
spring replacement |
10-11-2020, 01:00 PM | #3 | ||||||
|
spring replacement
i got it just as you said twist the spring.
however i some how broke the plunger pin for the ejector on the left barrel. Numrich calls it no. #48 on their schmatic. I am having a bad day, time to stop everything. now I need to repair or replace this part!! Thank you Bill E. |
||||||
The Following User Says Thank You to wilbert ericksen For Your Post: |
10-11-2020, 01:01 PM | #4 | ||||||
|
If you fully took the gun down, then your issue could be your Cocking bellcrank pin is not fully installed. If even the slightest bit of the pin is sticking out into the mainspring bore, it will prevent the spring from sliding into the bore.
This is really the only possible thing that can prevent the spring from installing. I got your email by the way about the broken plunger. I need to check inventory on that and get back to you. There is no reason that the spring should have to be “twisted” in. Again, I bet that pin is holding it up. It may be in there now by twisting it in, but it will not function properly as the obstruction is still in the way. I have taken apart and put back together hundreds of Parkers and have never had an issue re-installing a mainspring, except for in the scenario of a crank pin not being seated all the way.
__________________
B. Dudley |
||||||
The Following 3 Users Say Thank You to Brian Dudley For Your Post: |
10-11-2020, 01:38 PM | #5 | ||||||
|
thank you
|
||||||
10-11-2020, 02:35 PM | #6 | |||||||
|
Quote:
Brian, I'm not being snide here, just very curious - how can the bellcrank pin get out of place if I had never touched it or removed the cap screws to access it? .
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
|||||||
10-11-2020, 04:33 PM | #7 | |||||||
|
Quote:
I was not talking about your situation. I was talking about the OP’s. It sounded as if he took the action apart. I lended my thoughts based on what the issue may be based on my experience in working on the guns. Not that I dont believe you in what you are saying based on your experiences. I just dont have an explanation for it.
__________________
B. Dudley |
|||||||
The Following User Says Thank You to Brian Dudley For Your Post: |
spring replacement |
10-11-2020, 07:25 PM | #8 | ||||||
|
spring replacement
Thank you Brian that cocking hook was the problem!
All is well now except the broken plunger pin. |
||||||
10-11-2020, 07:42 PM | #9 | ||||||
|
I thought so.
I have a number of the ejector plungers. Will be in touch on the part.
__________________
B. Dudley |
||||||
|
|