![]() |
![]() |
![]() |
|||||||||||||||||||||||||||||||||||||||
|
![]() |
![]() |
![]() |
#3 | ||||||
|
![]()
This was at thirty yards . Two out of the left barrel . They’re lower left right off the paper .
__________________
Parker’s , 6.5mm’s , Mannlicher Schoenauer’s and my family in the Philippines ! |
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#4 | ||||||
|
![]()
I wanna try two punkin balls in the left barrel of my newest to me 8 and a load of buck in the right barrel on paper . That target was fired from the restored 8 hammer or rather the first I acquired .
__________________
Parker’s , 6.5mm’s , Mannlicher Schoenauer’s and my family in the Philippines ! |
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#5 | ||||||
|
![]()
Maybe a dumb question, knowing nothing about the 8 gauge, but do you use the 9 gauge balls in order to clear the chokes or to fit in the pastic shells?
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#6 | ||||||
|
![]()
To be honest I know not what size 9 gauge would be . I first ordered a round ball mold of size .775” and tried it in the restored hammer 8 . And over times used masking tape to kinda patch the ball and tighten it up a bit . Then this year I ordered molds of .785” and .795” after getting the PH 8 as it was slightly more open at the muzzle . I’ve since shot all three sizes in the restored gun . In this endeavor getting a decent grouping has been far easier than getting a really good POI in relation to POA .
__________________
Parker’s , 6.5mm’s , Mannlicher Schoenauer’s and my family in the Philippines ! |
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
|
|