Parker Gun Collectors Association Forums  

Go Back   Parker Gun Collectors Association Forums Parker Forums General Parker Discussions

Notices

Reply
Thread Tools Display Modes
SN break point from Meriden to Ilion-
Unread 09-17-2009, 04:50 PM   #1
Member
Old and Reliable
PGCA Member

Member Info
 
Join Date: May 2009
Posts: 1,246
Thanks: 1,674
Thanked 363 Times in 239 Posts

Default SN break point from Meriden to Ilion-

A friend has a family 12 gauge Trojan, believe was purchased in the 1930's. SN is 213917 and the rib has the Parker Trojan Steel marking, barrels are 28 and have the J.G. stamp in a circle- grade is marked OV- 4-1 weight stamp and in small case HT over the letter A- No Parker proof in an oval on each flat. This Trojan does not have the small top rib extension, it has the flat breech face as found on a M21 Winchester. My Brownell's boremaster shows right tube nominal BD at .730 with a 0.015" choke, left tube at .731 BD with a 0.025" choke. Gun has no colors left on receiver, stock shows years of wear, 80% barrel blueing, locks up tight and on face, safety and trigger mechanics are perfect--

On the graded Parkers, after the Remington purchase, they engraver PARKER on the bottom of the receiver (just back of the hinge pin area I believe) but this guns is not marked in that manner. Any insights would be appreciated, and passed on to my friend--
Francis Morin is offline   Reply With Quote
Unread 09-17-2009, 06:02 PM   #2
Member
Gunner
Forum Associate

Member Info
 
Join Date: Nov 2008
Posts: 231
Thanks: 1,456
Thanked 160 Times in 69 Posts

Default

Francis, If you check the manufacturing date by SN on the home page you will find the the gun is listed as manufactured in 1925. To early for a Remington gun.
Erick
Erick Dorr is offline   Reply With Quote
Unread 09-17-2009, 06:04 PM   #3
Member
Don Kaas
Forum Associate
 
Don Kaas's Avatar

Member Info
 
Join Date: Jun 2009
Posts: 560
Thanks: 0
Thanked 223 Times in 92 Posts

Default

The gun is a garden variety later production Trojan and was made in 1925, 9 years before the Remington takeover. Over 236,000 are usually Remington guns. All this information is easily accessible on this website.
Don Kaas is offline   Reply With Quote
Unread 09-17-2009, 06:12 PM   #4
Member
Dean Romig
PGCA Invincible
Life Member
 
Dean Romig's Avatar

Member Info
 
Join Date: Dec 2008
Posts: 32,073
Thanks: 36,785
Thanked 34,221 Times in 12,647 Posts

Default

However, if it has no "Parker Bros." on the the sides of the frame it may well have been an infinished gun in invertory after the Remington purchase of the Parker Gun Works in 1934. But that's nine years and it seems unlikely that a Trojan would have sat in obscurity in the Parker Bros. inventory that long. . . never say never?

The rib extension on the Trojan was eliminated somewhere around 1920 to 1923, probably earlier on the twelve gauge. I have a 1923 Trojan 16 ga. with the rib extension and haven't heard if anyone has a later example in 16 ga. 202066 is the serial no. on my Trojan.
Dean Romig is offline   Reply With Quote
Unread 09-17-2009, 07:49 PM   #5
Member
J.B. Books
PGCA Member
 
Pete Lester's Avatar

Member Info
 
Join Date: Jun 2009
Posts: 2,948
Thanks: 1,728
Thanked 5,074 Times in 1,431 Posts

Default

"Garden Variety"? I would bet the the folks at Parker would have disagreed that their economy gun was of garden variety. I think it's true now as it was then, if you have a desire to acquire and shoot a Parker, any Parker, it shows you have discriminating taste IMO.

If this was never engavoed "Parker Bros" on ths sides of the receiver perhaps it was an "employee" gun that somehow slipped through normal inspection.

I can tell you that in 1984 when lead was still legal for waterfowling I shot my first two ducks with a Parker, a 12ga Trojan. After shooting an 870 for several years I was absolutely stunned by the range and performance with 2 3/4" shells in that gun. Two shots and I knew I had something quite special.
Pete Lester is offline   Reply With Quote
Unread 09-17-2009, 08:32 PM   #6
Member
Don Kaas
Forum Associate
 
Don Kaas's Avatar

Member Info
 
Join Date: Jun 2009
Posts: 560
Thanks: 0
Thanked 223 Times in 92 Posts

Default

"garden variety"- something ordinary or standard...The Trojan in question sounds like an oridinary or standard Trojan made in Meriden, i.e. not a special Trojan. Parker likely lost money on every Trojan it made. I'm pretty sure an order for 10 D grades made Walter or Charles King a good deal happier than one for 25 Trojans...I shot my very first two ducks (a blackie and a woodie drake over a half frozen beaver pond near Epping, NH) 43 seasons ago with a Fox Sterlingworth 16 gauge but I am sure your moment with a Trojan was much more "special" than mine was...
Don Kaas is offline   Reply With Quote
Unread 09-17-2009, 09:13 PM   #7
Member
J.B. Books
PGCA Member
 
Pete Lester's Avatar

Member Info
 
Join Date: Jun 2009
Posts: 2,948
Thanks: 1,728
Thanked 5,074 Times in 1,431 Posts

Default

Quote:
Originally Posted by Don Kaas View Post
I shot my very first two ducks (a blackie and a woodie drake over a half frozen beaver pond near Epping, NH) 43 seasons ago with a Fox Sterlingworth 16 gauge but I am sure your moment with a Trojan was much more "special" than mine was...
Don it most certainly had to be.......afterall you weren't shooting a Parker

But then again my first two shots brought down a Black and Greenhead in Dover whereas you were in Eppin', known to locals as the Center of the Universe.
Pete Lester is offline   Reply With Quote
My friend's Trojan 12
Unread 09-17-2009, 11:13 PM   #8
Member
Old and Reliable
PGCA Member

Member Info
 
Join Date: May 2009
Posts: 1,246
Thanks: 1,674
Thanked 363 Times in 239 Posts

Default My friend's Trojan 12

Thanks to all- I forgot to check the SN listing first. I loaned my copy of Peter Johnson's book on the Parker- but I thought he had mentioned the elimination of the top rib extension on the economy model around 1930. Also, this gun does have the Parker Bros. script style engraving on both side of the receiver, my question was, as later Remington graded Parkers often had PARKER engraved on the BOTTOM of the receiver, I wondered if they did that with the Trojan as well. The OV stamp on the barrel flats- was that used on all Trojans from 1915 through 1940 (aprox.) ??

I agree with those who proclaim the Trojan Parker as great shooting shotgun, no "frills" but that pair of ducks that were "dropped" whether by a Parker Trojan or a Fox Sterlingworth or later on, perhaps a Winchester Model 24- most likely weren't aware of the gauge or grade of shotgun that brought about their demise- the skill of the shooter and good gun fit nonwithstanding!!
Francis Morin is offline   Reply With Quote
Unread 09-18-2009, 09:55 AM   #9
Member
Bruce Day
PGCA Lifetime
Member
 
Bruce Day's Avatar

Member Info
 
Join Date: Nov 2008
Posts: 4,995
Thanks: 554
Thanked 15,664 Times in 2,672 Posts

Default

Francis, yes and yes. An inexpensive (about $35) and good reference book for Parkers is the Parker Guns Identification and Serial Number book.
Bruce Day is offline   Reply With Quote
New Book Search--
Unread 09-18-2009, 06:00 PM   #10
Member
Old and Reliable
PGCA Member

Member Info
 
Join Date: May 2009
Posts: 1,246
Thanks: 1,674
Thanked 363 Times in 239 Posts

Default New Book Search--

Quote:
Originally Posted by Bruce Day View Post
Francis, yes and yes. An inexpensive (about $35) and good reference book for Parkers is the Parker Guns Identification and Serial Number book.
Thanks Bruce. The only other Parker references I have at present are Larry Baer's 1977 Parker Book and Mike McIntosh's 1989 "Best Guns"- with Mr. M's "slight bias therein" for the fine boxlocks from Phila. PA- his advice about "restoring a VHE and then wanting to sell it to get into a higher grade (page 268) applies to all good doubles (IMO) and also reflects his accumen at the poker table.

If this book you recommend is available through the PGCA network, I will purchase it soon-if not, I'll check the e-bay and other book sources. I realize that some of the information available to the late Mr. Johnson in 1959 has been updated greatly, and by hard work and diligence by many PGCA members. We all should be grateful for that, whether we own a PH 16 gauge or an AAHE 28 gauge-Thanks again!!
Francis Morin is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:50 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Parkerguns.org
Copyright © 2004 Design par Megatekno
- 2008 style update 3.7 avec l'autorisation de son auteur par Stradfred.