|
 |
 |
||||||||||||||||||||||||||||||||||||||
Visit Mike Koneski's homepage! | | ||||||||||||||||||||||||||||||||||||||
 |
 |
11-16-2024, 09:24 AM
|
#3 | ||||||
|
other far less expensive options....
|
||||||
|
|
||||||
 |
 |
 |
| The Following 2 Users Say Thank You to randall rosenthal For Your Post: |
|
|
|
11-16-2024, 11:46 AM
|
#4 | ||||||
|
I have looked and bought shells but a limited supply as stated.I'm not complaining just inquiring if anyone has any inside knowledge.Five years ago they were stocked and at the Southern SXS with a full trailer.Now limited stock I would think components would be available now.Most other suppliers and manufacturers are.Cost is a whole other issue.
|
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to Bob Hayes For Your Post: |
|
|
|
11-16-2024, 03:16 PM
|
#5 | ||||||
|
How dependent were RST recipes on Alliant or other hard to impossible to get powders? Many Remington wads are also not available. Things are far from the pre Covid days when it comes to reloading components.
__________________
Progress is the mortal enemy of the Outdoorsman. |
||||||
|
|
|
||||||
|
|
|
| The Following 6 Users Say Thank You to Pete Lester For Your Post: |
|
|
|
11-16-2024, 05:46 PM
|
#6 | ||||||
|
Randall, what are the pressure levels of the shells you picture? Morris Baker and RST claims lower pressures suitable for composite barrels. Other makers of short shells with light shot loads do not make those claims.
|
||||||
|
|
|
||||||
|
|
|
| The Following 4 Users Say Thank You to Bill Murphy For Your Post: |
|
|
|
11-16-2024, 09:42 PM
|
#7 | ||||||
|
To Mr Murphy’s point, I purchased several boxes of 2 1/2” Shenk brand shells only to find they are way beyond safe in our vintage side by sides.
__________________
A Dog, A Gun, and Time enough! George Bird Evans |
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to Rick Roemer For Your Post: |
|
|
|
11-16-2024, 10:49 PM
|
#8 | ||||||
|
Last time I spoke with Morris he told me that the powder they use for the low pressure loads is the same that is used fore some of the military purposes. That’s one of the reasons…
.
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to Dean Romig For Your Post: |
|
|
|
Yesterday, 10:09 AM
|
#9 | |||||||
|
Quote:
|
|||||||
|
|
|
|||||||
|
|
|
|
|
|
Yesterday, 07:16 PM
|
#10 | ||||||
|
If you can find them, Gamebore 2.5 inch has made its way into the US. They are excellent.
|
||||||
|
|
|
||||||
|
|
|
 |
|
|
Linear Mode
