Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Located and purchased a Hemenway's New Model Damascus SxS today. Real nice overall condition. The big question I have is the underside of the barrels are stamped "13", what does that mean? I believe the gun is a 12 bore, but perhaps a 13 bore? A 12 gauge shell fits nicely though. Check out the many photos. Someone here knows about these London or Birmingham guns. Looks similar to the early Isaac Hollis guns. The carved horn butt plate and for-end tip are well done as are the engraved side plates and bolsters. A surprising amount of "case color" still exists. Oh, the serial number is kind of low...#46. I didn't give a whole bunch for the piece (you'd laugh) but with the condition I felt it needed to go home with me. The quality is perhaps arguably similar to a Parker top lever "D" grade. The barrels measure a touch over 30 1/8". The bores are absolutely perfect and shiny. My appreciation for Parker Guns has opened my eyes to other vintage side by sides and hope you can understand, though Parker Bros. are my favorite.
The Following 11 Users Say Thank You to Bruce Bruner For Your Post:
Sweet Bruce. That is an uncommon 'English Best' Turkish variant called 'Rosen', with a weld line down the middle of each scroll.
I added a couple of your pics, with an attribution, at the bottom here http://www.picturetrail.com/sfx/album/view/18059733
Rosa damascena
'13' means the bore at proof was .710-.718, '13/1' = .719-.728, and '12' .729.
What is the bore now?
Drew, Thank you for the very informative link. I'm honored you added my photographs to the link. Do you think the Hemenway is really an Isaac Hollis with the Hemenway name? The serial number sure is low. Simply using a caliper: L-.711 R-.715 are the current bore measurements. I'm very appreciative for the knowledge shared here. Bruce
To put a finer point on what OH has said, this gun was proofed at 13 bore, but chambered as a 12. If the tubes are still under .729, it's probably still closer to 13. Proofs are Birmingham. And the left barrel was made with choke. It may still have some.
English barrel lengths were often give or take a 1/2" or so. Don't worry that.
Overall, this is a very fine example of a good English gun. With a surprising amount of colour case left. With light nitro loads, it should be fine.
You got a very good bargain here!
Best, Kensal
The Following 2 Users Say Thank You to John Campbell For Your Post:
02-19-2013, 06:54 PM
Linear Mode
