|
01-30-2017, 01:08 PM | #3 | ||||||
|
I use the same load in all my 10ga hulls : Rem, Win, and Fed. They're all a straight walled hull as the Cheddite, and at the pressures we're reloading at I can't see a problem. 19 of RD or 21 of GD. But that's JMHO.
__________________
Paul Harm |
||||||
The Following User Says Thank You to Paul Harm For Your Post: |
01-30-2017, 02:32 PM | #4 | ||||||
|
I use the 19 grain 1&1/8 oz Red Dot load in my Cheddite hulls. Either the Cheddite primer or Winchester. ( My average drop with MEC bushing is 18.6 grains) Load works very well. I also use this with Federal and Remington hulls. My 2 short ten's are not choked all that tight but they can break clays pretty far out there. Just a very nice low pressure load that works!
|
||||||
The Following User Says Thank You to Eric Johanen For Your Post: |
|
|