|
 |
 |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
 |
06-05-2016, 02:17 PM
|
#3 | ||||||
|
It is a narrow slot to be sure. That's why most of them are buggered. I had to grind my Brownells.
.
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
||||||
|
|
||||||
 |
 |
 |
|
|
|
06-05-2016, 02:53 PM
|
#4 | ||||||
|
one of the set i have from Brownwells is their narrow slot set
often still need some work to fit - but less than the grinding the normal ones
__________________
"If there is a heaven it must have thinning aspen gold, and flighting woodcock, and a bird dog" GBE |
||||||
|
|
||||||
|
|
|
|
|
|
06-05-2016, 04:04 PM
|
#5 | ||||||
|
What Rick said. I also found the Browning A5 set to have what I needed for the hammer screw slot. Cheaper.
http://www.brownells.com/gunsmith-to...prod44342.aspx http://www.brownells.com/gunsmith-to...prod25476.aspx |
||||||
|
|
|
||||||
|
|
|
|
|
|
06-05-2016, 05:22 PM
|
#6 | ||||||
|
Brownell's 300-2 will fit most hammer screws. Some may take a 300-1. Cheers, Tom
|
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to Tom Carter For Your Post: |
|
|
|
06-05-2016, 07:22 PM
|
#7 | ||||||
|
Good Tip Tom
Ordering up some now, Looking at the Brownell's Magna Tip selection they sell a pair of small grinding wheels, large and small, right size to hollow grind the bit's too. Just the ticket for dressing one up to exact size. William |
||||||
|
|
|
||||||
|
|
|
 |
|
|
Linear Mode
