|
08-08-2015, 08:38 PM | #3 | ||||||
|
Thanks for quick response .yes lever moves too right. Safety resets.a little movement but tiny amount in barrels. And will not open no matter what I do for end off or on sprayed action with break free and down the barrel. Poked inside of empty she'll with a cleaning rod and nothing works.
|
||||||
08-08-2015, 09:06 PM | #4 | ||||||
|
I had a Parker where the safety reset rod was not original and it was a bit to long. It would not allow the bolt to fully clear the bite. Putting more pressure on the lever when to the right would allow the gun to open. Since the safety resets, it sounds like the bolt is retracting but maybe not fully. Do these Fiochi's have a steel rim? If so, try opening the gun while someone else uses a ramrod down the barrel, pushing hard against the empty shell. If you do get it open, try dry firing. If it works empty, it is p problem with the shells.
|
||||||
08-08-2015, 09:23 PM | #5 | ||||||
|
Ok will give it a try thanks for responding.
|
||||||
08-09-2015, 01:24 PM | #6 | ||||||
|
We have had issues over the years with various O/U guns locking up. The problem was the firing pins would hang up in the primer and not allow for the action to open. Happened a lot with the cheap Winchester Universal shells. I'd say any shell with a soft primer or an over long FP could do it. Same symptoms as your gun, top lever fully right and just a very small amount of movement when trying to open the action. I shoot a lot of Fiocchis and never had a problem, so, I'd say check your firing pins and even just shoot a few boxes of another brand of shell. Maybe your Fiocchis have a different primer for some reason?
|
||||||
08-09-2015, 01:33 PM | #7 | ||||||
|
Hey thanks mike.i think you are exactly right .but my problem is I still can't get the gun to open and remove the empty she'll I've tried everything.there must be someway to get the firing pin pushed back but I have tried all suggestions.
|
||||||
08-09-2015, 01:46 PM | #8 | ||||||
|
Just a wild assed guess here but how about pouring some clean 30wt oil down the barrel and then follow with a tight patch and jag. Whack the end of the rod with a hammer and develop some hydraulic pressure. It might just work.
|
||||||
08-09-2015, 03:31 PM | #9 | ||||||
|
I would worry about soaking the wood with all that oil?
|
||||||
08-09-2015, 04:11 PM | #10 | ||||||
|
Can u get it open a little and use a feeler gauge or such get it between pin and shell head
__________________
Father, will I be able to be brave when I am afraid? Child, that is the only time one can be brave. |
||||||
|
|