Parker Gun Collectors Association Forums  

Go Back   Parker Gun Collectors Association Forums Announcement, Help & Introduction Forums Website & Forum - Help & Assistance

Notices

Reply
Thread Tools Display Modes
Before or after Remington
Unread 02-17-2020, 04:58 PM   #1
Member
William Routh
Forum Associate

Member Info
 
Join Date: Feb 2020
Posts: 6
Thanks: 0
Thanked 5 Times in 3 Posts

Default Before or after Remington

I inherited a grade 2 GH in childhood that was apparently purchased in 1934 based on serial #. How might I determine if it was manufactured before or after Remington acquired Parker?
William Routh is offline   Reply With Quote
Unread 02-17-2020, 07:44 PM   #2
Member
Garth Gustafson
PGCA Member
 
Garth Gustafson's Avatar

Member Info
 
Join Date: Feb 2013
Posts: 627
Thanks: 1,771
Thanked 1,497 Times in 397 Posts

Default

The simple answer is if the gun says Parker Brothers, it was built prior to the Remington purchase in 1934. If it says Parker, it was likely built after Remington bought the company. But there are exceptions.
Garth Gustafson is offline   Reply With Quote
The Following 2 Users Say Thank You to Garth Gustafson For Your Post:
Unread 02-17-2020, 07:54 PM   #3
Member
Dean Romig
PGCA Invincible
Life Member
 
Dean Romig's Avatar

Member Info
 
Join Date: Dec 2008
Posts: 32,073
Thanks: 36,788
Thanked 34,224 Times in 12,648 Posts

Default

Not quite so...

The purchase and sale of the Parker gun works officially took place on June 15, 1934.

Several Parkers finished after that date have Parker Brothers features and identifiers.

Case in point, the “transition” guns with no makers mark at all on the exterior of the frames.






.
__________________
"I'm a Setter man.
Not because I think they're better than the other breeds,
but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture."

George King, "That's Ruff", 2010 - a timeless classic.
Dean Romig is offline   Reply With Quote
The Following 2 Users Say Thank You to Dean Romig For Your Post:
Unread 02-18-2020, 09:42 AM   #4
Member
William Routh
Forum Associate

Member Info
 
Join Date: Feb 2020
Posts: 6
Thanks: 0
Thanked 5 Times in 3 Posts

Default

In response to the previous information have attached photos. “Parker Bros” is stamped as the maker. And some of the other engraving is exhibited. Can I say this was a “pre-Remington” gun?

Also, the name of the original owner is engraved on the stock as seen. Would this have been done at the factory or after it was delivered? Thanks
William Routh is offline   Reply With Quote
Unread 02-18-2020, 12:07 PM   #5
Member
Dean Romig
PGCA Invincible
Life Member
 
Dean Romig's Avatar

Member Info
 
Join Date: Dec 2008
Posts: 32,073
Thanks: 36,788
Thanked 34,224 Times in 12,648 Posts

Default

Where are the photos?

And what is the serial number?




.
__________________
"I'm a Setter man.
Not because I think they're better than the other breeds,
but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture."

George King, "That's Ruff", 2010 - a timeless classic.
Dean Romig is offline   Reply With Quote
Unread 02-18-2020, 01:11 PM   #6
Member
William Routh
Forum Associate

Member Info
 
Join Date: Feb 2020
Posts: 6
Thanks: 0
Thanked 5 Times in 3 Posts

Default

Sorry-I had neglected to hit the “upload” button-novice mistake. Hopefully they are now attached. Thx
William Routh is offline   Reply With Quote
The Following User Says Thank You to William Routh For Your Post:
Unread 02-18-2020, 01:45 PM   #7
Member
Dean Romig
PGCA Invincible
Life Member
 
Dean Romig's Avatar

Member Info
 
Join Date: Dec 2008
Posts: 32,073
Thanks: 36,788
Thanked 34,224 Times in 12,648 Posts

Default

That is a “transition” gun made during the first few months of Remington ownership.





.
__________________
"I'm a Setter man.
Not because I think they're better than the other breeds,
but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture."

George King, "That's Ruff", 2010 - a timeless classic.
Dean Romig is offline   Reply With Quote
Unread 02-18-2020, 01:49 PM   #8
Member
William Routh
Forum Associate

Member Info
 
Join Date: Feb 2020
Posts: 6
Thanks: 0
Thanked 5 Times in 3 Posts

Default

Dean-thank you so much for your insights. I am passing this gun along to my son after almost 60 years and he has been motivated to learn more about it. Regards, Bill Routh
Chattanooga, TN.

Last edited by William Routh; 02-18-2020 at 03:02 PM..
William Routh is offline   Reply With Quote
The Following 3 Users Say Thank You to William Routh For Your Post:
Unread 02-18-2020, 04:44 PM   #9
Member
Dean Romig
PGCA Invincible
Life Member
 
Dean Romig's Avatar

Member Info
 
Join Date: Dec 2008
Posts: 32,073
Thanks: 36,788
Thanked 34,224 Times in 12,648 Posts

Default

William, in doing a bit more research I find some discrepancies in available historical data....

We know that ownership of the Parker Gun Works went to Remington on June 15, 1934

Data shows that the first Parker produced by Remington was 236531 sometime shortly after 6/15/34

Your Parker, no. 236401, without any "Parker" engraving, was obviously produced by Remington shortly after that date. Yours is an excellent example that frames, barrels and other parts were fitted and serialized and held in the rack waiting for an order to come in that would require 236401 to be finished AFTER the transfer of ownership.

Burt Spiller's VH no. 236252 was shipped on April 15, 1934, two months before the transfer of ownership.

Parker Brothers produced just 289 guns in 1934 prior to the transfer of ownership and Remington produced 464 guns in 1934 after the transfer.

I owned Parker no. 235908 which had Parker Bros. engraved on the sides of the frame and I have Parker no. 236912 with Parker engraved only on the bottom of the frame. Those are the only two Parkers I have owned that close in production to that June 15, 1934 date.





.
__________________
"I'm a Setter man.
Not because I think they're better than the other breeds,
but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture."

George King, "That's Ruff", 2010 - a timeless classic.
Dean Romig is offline   Reply With Quote
The Following 2 Users Say Thank You to Dean Romig For Your Post:
Unread 02-18-2020, 04:50 PM   #10
Member
William Routh
Forum Associate

Member Info
 
Join Date: Feb 2020
Posts: 6
Thanks: 0
Thanked 5 Times in 3 Posts

Default

Dean, thanks so much. Will pass along to my son.
William Routh is offline   Reply With Quote
The Following User Says Thank You to William Routh For Your Post:
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:31 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Parkerguns.org
Copyright © 2004 Design par Megatekno
- 2008 style update 3.7 avec l'autorisation de son auteur par Stradfred.