|
12-21-2010, 11:48 AM | #3 | ||||||
|
Eric if Dave Miles doesn't reply to this post (he has been busy) send him a pm I know he loads Cheddite hulls and low pressure loads . Eric
|
||||||
12-21-2010, 11:52 AM | #4 | ||||||
|
Thanks that sets me up. Just need the wads. I have a pile of cheddite primers.
Real helpful! |
||||||
12-21-2010, 04:27 PM | #5 | ||||||
|
Grafs is out of the gu 1225 and I am striking out on finding another dealer. Would appreciate it if anyone knows who else would carry them or if there is an equivalent from another manufacturer. Thanks
|
||||||
12-21-2010, 05:31 PM | #6 | ||||||
|
Looks like Gualandi wads at the bottom of the page?
http://www.ballisticproducts.com/Wad...s/products/86/ Drats!! out of stock to !!
__________________
"Double guns are a sport and a pastime built into a beautiful package to which I attach myself when entering the great theater of autumn, those days now grow more precious because we are given so few".. Robin Lacy |
||||||
12-22-2010, 07:14 AM | #7 | |||||||
|
Quote:
How many do you need? I'll check my inventory tonight, might have some to spare. |
|||||||
12-23-2010, 06:02 PM | #8 | ||||||
|
Dave,
That is very generous of you. I don't need many at this time as I am in winter reloading mode getting ready for spring and the club is snowed in right now. Enough for a round of skeet would do as I want to test out a new/old GH I just acquired. Trade you some Vermont maple syrup. Thanks! |
||||||
12-23-2010, 07:31 PM | #9 | |||||||
|
Quote:
I don't reload 2-3/4" Cheddite hulls any more, but I have 400 of the 1225 wads left. E-mail me your info and I'll send you however many of the 400 you want, right after X-mas. asphaltdave@comcast.net |
|||||||
12-23-2010, 07:42 PM | #10 | ||||||
|
I have a couple loads, that I had tested by Tom Armbrust.
New 2-1/2" Cheddite hull. Can be purchased from Graff's and sons. It comes primed with Cheddite primer, but you can use Win. 209 after. 20 grains International Clays GU-1222 wad. can also get from Graff's. 1 oz. lead shot 1200 FPS @ 6800 PSI If you adjust your reloader correctly, you'll get perfect crimps, with either 6 or 8 point crimp. You can also use: 21 grains of IMR-PB for 1125 FPS @ 6000 PSI 22 grains of IMR-PB for 1225 FPS @ 7200 PSI These loads were also tested. Regards, Dave If your loading 2-3/4" hulls, you can use the same load data listed above, except use the GU-1225 wad. Pressure and velocity will be the same. |
||||||
The Following 2 Users Say Thank You to Dave Miles For Your Post: |
|
|