|
01-25-2010, 01:07 PM | #3 | ||||||
|
Pictures...
|
||||||
01-25-2010, 02:28 PM | #4 | ||||||
|
thanks harry does anybody change the"role" now? ch it has about 8 thousants lash at face what thickness shim stock would u start with?
Last edited by calvin humburg; 01-25-2010 at 02:31 PM.. Reason: 4got some |
||||||
01-25-2010, 02:58 PM | #5 | ||||||
|
Calvin,
If you start with .005 and it's still loose than go a little heavier. I recently had Russ Bickle tighten a 16 gage for me by adding material to the barrel hook. This is much easier and less expensive than replacing the roll joint. If you really wanted to replace the roll joint I believe DelGregos has them in various sizes and would be a good choice for that repair. |
||||||
The Following User Says Thank You to Larry Frey For Your Post: |
01-27-2010, 07:00 AM | #6 | ||||||
|
Larry,
Going 2 get some brass 2day. I can't find DelGregos on the internet. ch |
||||||
01-27-2010, 07:10 AM | #7 | ||||||
|
Del Grego, Ilion, NY
|
||||||
The Following User Says Thank You to Dean Romig For Your Post: |
01-27-2010, 12:16 PM | #8 | ||||||
|
Calvin: Larry Del Grego & Sons
1757 Barringer Road Ilion, New York 13357 Phone315) 894-8754 Best Regards, George |
||||||
The Following User Says Thank You to George Lander For Your Post: |
Parker roll=-rejointing and hinge pin wear |
01-27-2010, 03:10 PM | #9 | ||||||
|
Parker roll=-rejointing and hinge pin wear
Calvin, if you don't mind- I'm a bit curious as to how you determined the 0.0080" wear or gap at the hinge-- Harry's remarks about using brass shim stock is one very good way to go, having Larry Del Greco install a new hinge pin to 'size" is certainly another- it is also possible, in some cases, to rebuild the wear surface of the hinge pin with spray well and remachining- I have never removed a hinge pin from a Parker (or a Smith) but I believe the set screw is a LH thread (as you will find in the triiger housing group of a M12 for example)--
When you state "off face" did you mean when the forearm is removed with the gun cocked, you can "wiggle" the barrels slightly- another test is to then either mount it into your shoulder pocket with a bit of "ommph" or smack the buttplate/recoil pad to see if there is any laternal "shuck" or movement- if so, that might mean the bolt wear plate or wear in the doll's head area- hard to know for sure. There are many very fine Parker gunsmiths extant, and thank the Lord for that- The "advantage" the Del Greco's have is the long generations of ties to the Parker gun and also their inventory of original Parker parts. Their reputation speaks for itself-- Best of luck with the repairs-- |
||||||
01-27-2010, 09:30 PM | #10 | ||||||
|
Francis,
I thought (thought being the key word) loose on the face ment it had space between the top of barrel and top of receiver. stuck feeler gauge between barrel and flat piece the firing pins r in 8 thousants was a liberal number. The hing just watching the gap around the hing don't move much around 1 thousant havent tried it with forend off will tomarrow gun at farm. Can't get any play trying 2 stretch and contract whole gun. bet all that is as clear as mud. ch |
||||||
The Following User Says Thank You to calvin humburg For Your Post: |
|
|